Conditions On Site; Ambient Temperature; Moisture And Corrosion Protection; Deposits - HBM U10M Montageanleitung

U10M, U10S
4

Conditions on site

Protect the transducer from weather conditions such as rain, snow, ice and
salt water.

4.1 Ambient temperature

The temperature effects on the zero signal and on the sensitivity are compen-
sated.
To obtain optimum measurement results, the nominal (rated) temperature
range must be complied with. The arrangement of the SG results in high in-
sensitivity to temperature gradients due to the construction. Nevertheless,
constant or very slowly changing temperatures are best. A radiation shield
and all-round thermal insulation produce noticeable improvements, but must
not be allowed to set up a force shunt.

4.2 Moisture and corrosion protection

The force transducers are hermetically encapsulated and are therefore very
insensitive to moisture. The transducers reach the protection class IP67 per
DIN EN 60 259 (test conditions: 0.5 hours under 1 m water column). Never-
theless, the force transducers must be protected against permanent moisture
influence.
The transducer must be protected against chemicals that could attack the
steel (nominal (rated) forces from 12.5 kN) or aluminum (nominal (rated)
forces up to 5 kN).
With stainless steel force transducers, please note that acids and all materials
which release ions will also attack stainless steels and their welded seams.
Should there be any corrosion, this could cause the force transducer to fail. In
this case, appropriate protective measures must be implemented.

4.3 Deposits

Dust, dirt and other foreign matter must not be allowed to accumulate suffi-
ciently to divert some of the measuring force onto the housing, thus invalidat-
ing the measured value (force shunt). The relevant areas are marked in
Fig 4.1.
A1385−6.0 en/de/fr
13
HBM