Saving Battery Data - VOLTCRAFT Ultimate 400 W Bedienungsanleitung

14. SAVING BATTERY DATA

The charger has altogether 10 memories in which you can save battery data/settings.
• In the main menu, select the function „SAVE DATA" with the button „BATT TYPE/STOP":
PROGRAM SELECT
• Press the „START/ENTER" button, the display shows the following, for example, and
memory „01" flashes:
SAVE [01]
3.7V
• Select the desired memory slot with the buttons „INC" or „DEC" (1... 10) and confirm your
entry with the „START/ENTER" button.
• Now the battery type, which you can change with the buttons „INC" or „DEC" flashes on
the top right of the display. Confirm the selection by pressing the „START/ENTER"
button.
It is not possible to select between „LiPo", „LiIon" and „LiFe". The type set in the user
menu (see chapter 16) is always applied.
• The voltage starts to flash on the bottom left. Change this as usual using the buttons
„INC" and „DEC" and confirm the value using the „START/ENTER" button.
• Now the battery capacity flashes on the bottom right. Set this with the buttons „INC" or
„DEC" (keep button depressed for longer for fast changing) and confirm this with the
button „START/ENTER".
• Then the memory number flashes again.
• Keep the button „START/ENTER" depressed (for approx. 3 seconds) to access the next
menu, then let the button go again immediately. The following display appears
(depending on the previously selected battery type):
NiMH CHARGE
CUR LIMIT
SAVE DATA
LiPo
2000mAh
At*
4.0A
LiPo CHARGE
1.0A 7.4V(2S)
*
81