Saving Battery Data - VOLTCRAFT B6 Duo Bedienungsanleitung

14. SAVING BATTERY DATA

The charger has 10 independent memory slots for each charging channel, in which you
can save battery data/settings.
Example: If you stored data for a LiPo battery in charging channel 1, memory slot
"01", you may store, for example, NiMH battery data in charging channel 2, memory
slot "01".
However, it is not possible to exchange stored data between the two charging
channels (e.g. from memory slot "01" in the 1st charging channel to memory slot "01"
in the 2nd charging channel.
Just programme the same data into both charging channels.
• In the main menu, select the function "SAVE DATA" with the button "TYPE/STOP":
PROGRAM SELECT PROGRAM SELECT PROGRAM SELECT
PROGRAM SELECT PROGRAM SELECT
• Press the button "ENTER/START"; the display shows the following, for example, and
memory "01" flashes:
SAVE [01] SAVE [01]
SAVE [01] SAVE [01] SAVE [01]
3.7V 3.7V 3.7V
3.7V 3.7V
• Select the desired memory slot with the buttons "+" or "-" (1...10) and confirm your entry
with the button "ENTER/START".
• Now the battery type, which you can change with the buttons "+" or "-" flashes on the top
right of the display. Confirm the selection by pressing the "ENTER/START" button.
It is not possible to select between "LiPo", "LiIon" and "LiFe". The type set in the user
menu (see chapter 16) is always applied.
• The voltage starts to flash on the bottom left. Change this as usual using the buttons "+"
and "-" and confirm the value using the "ENTER/START" button.
• Now the battery capacity flashes on the bottom right. Set this with the buttons "+" or "-"
(keep button depressed for longer for fast changing) and confirm this with the button
"ENTER/START".
• Then the memory slot number flashes again.
SAVE DATA SAVE DATA
SAVE DATA SAVE DATA SAVE DATA
LiPo LiPo
LiPo LiPo LiPo
2000mAh 2000mAh 2000mAh
2000mAh 2000mAh
87