Spa Maintenance - Jacuzzi J-200 Serie Montageanweisung Und Bedienung Und Wartung

To reset the duration countdown timer:
Press Press
Press
Press
Press Press
Press
Press
1
Will reset the timer to
Will reset the timer
to 365 days and exit
365 days and exit the
the menu
menu
Press and hold Jets pump 1 (
me time for 3 seconds.
Press the Warmer ( ) button until the display shows "0".
If the timer has reached "0", pressing the Jets pump 1 (
ton will reset the timer to 365 days. If the timer is not at "0" pres-
sing the Jets pump 1 button will not reset it.
Note: If the spa power is interrupted, the duration countdown
timer is not affected. The number of days remaining is stored in
the memory and will continue to countdown once power is re-
gained.
If the duration countdown timer is not at "0" and you need to re-
set it:
A. Press and hold the Jets pump 1 and Cooler buttons at the
same time for 3 seconds.
B. Press the Warmer button to scroll to "U".
C. Press the Jets pump 1 button to switch from "U" to "O3".
C. Press and hold the Jets pump 1 and Cooler buttons at the
same time for 3 seconds.
E. Press the Warmer button to scroll to "O3".
D. Press the Jets pump 1 button to switch from "O3" to "U". The
timer has been reset to 365 days.

Spa maintenance

Proper and regular maintenance of your spa will help it retain
its beauty and performance.
I
Cleaning the filter (models J-210)
The Jacuzzi ® Premium spa is equipped with a basket and a high-
performance filter cartridge, located in the compartment on the
inner wall of the spa.
Impurities are filtered by the pump which draws water into the
basket and filter cartridge which, for best performance, must be
cleaned about once a month, depending on frequency of use of
the spa. For this purpose, proceed as follows:
A. Turn off power to spa.
B. Remove the cover, unscrew the cartridge and extract it.
C. Rinse the impurities out of the folds in the filter using pres-
surised water. Work from the top down. Repeat until all folds are
clean.
Press Press Press
Press
Press Press
Press Press
Press
Press
) and Cooler ( ) at the sa-
1
I
Cleaning the filter (models J-230, J-270 and J-280)
These models are equipped with a bag and a high-performance
filter cartridge, located under the cover, as shown below.
Impurities are filtered by the circulation pump (if included) or by
pump 1, which draws water into the bag and filter cartridge
which, for best performance, must be cleaned about once a
month, depending on frequency of use of the spa. For this pur-
pose, proceed as follows:
A. Turn off power to spa.
B. Remove the cover by lifting it
C. Release the skimmer bag from the clips and clean it.
D - E. Remove the filter cartridge by turning it counter-clockwise
) but- (to release it from the fitting) and extract it.
1
F. Rinse the impurities out of the folds in the filter using pres-
surised water. Work from the top down. Repeat until all folds are
clean.
G. Immerge the cartridge of the filter in the spa, with the thread-
ed end up to remove trapped air bubbles. Then hold the cartridge
under water, so as to prevent possible air bubbles from forming
during installation.
H. Place the cartridge back in the housing, and turn it clockwise
to re-install it on the fitting.
Note the direction of installation.
Do not over tighte
n.
I. Install clean skimmer bag back onto clips.
J. Install the filter cover. Turn power to the mini-pool back on.
B
E
25
D
C
F G