Winterizing; Restarting Your Spa In Cold Weather; Water Quality Maintenance - Jacuzzi J-200 Serie Montageanweisung Und Bedienung Und Wartung

To prolong the life of the cover, handle it with care and clean it
regularly using mild soap and water or specific products.
N.B.: Never allow anyone to stand or sit on the cover.
Panel maintenance
The panels do not require any special maintenance. To clean them,
just wipe them with a clean cloth and a neutral detergent solution.
ATTENTION: do not direct jets of water against the panels,
since electro-mechanical parts are located behind them.

Winterizing

I
Your Jacuzzi ® Premium spa is designed to automatically protect
itself against freezing when operating properly.
I D
uring periods of severe freezing temperatures, you should
check periodically to be certain that the electrical supply to the s-
pa has not been interrupted.
I
In extreme cold weather, choose the F3 "Standard" skim-
ming/heating mode to prevent freezing.
I
If you do not intend to use your spa, or if there is a prolonged
power outage during periods of severe freezing temperatures, it is
important that all water be removed from the spa and equipment
to protect against damage from freezing.
For expert winterization of your spa, contact your author-
ized dealer.
In emergency situations, damage can be minimized by taking the
following steps:
- Disconnect the spa from the electric mains.
- Follow the directions for draining the spa.
- Remove the water from the recessed seating areas and bottom.
- Position the massage switch in position A (combo).
B C
A
- Open the valve of the cascade with the correct knob.
- Remove the side cover panels and locate the pump drain plugs. Re-
move them to allow water to drain from the pumps and the heater.
Use a vacuum or other means to keep the water from flood-
ing the system compartment.
- Re-install the plugs of the pumps and the cabinet panels and cov-
er the spa with the insulating cover.

Restarting your spa in cold weather

If you want to start up your spa after it has sat empty for a time
in freezing temperatures, check whether the water remaining in
certain sections of the piping is still frozen: this situation may
block water flow preventing the spa from operating properly and
possibly damaging the equipment.
We recommend you consult your dealer for guidance before
attempting to restart your spa under these conditions.

Water quality maintenance

Maintaining the quality of the water within specified limits will
serve to enhance your enjoyment and prolong the life of the sys-
tem. It is a fairly simple task, but it requires regular attention be-
cause the water chemistry involved is a balance of several factors.
A careless attitude in regard to water maintenance will result
in poor and potentially unhealthy conditions for soaking and
may even damage your spa.
For specific guidance on maintaining water quality, consult your
dealer who can recommend appropriate chemical products for
sanitizing and maintaining your spa.
CAUTION: Never store mini-pool chemicals in the com-
partments located under the spa.
pH Control
pH is a measure of relative acidity or alkalinity of water and is meas-
ured on a scale of 0 to 14. The midpoint of 7 is said to be neutral.
Above this value the water is alkaline and below it, it is acidic.
IT IS VERY IMPORTANT TO MAINTAIN A SLIGHTLY AL-
KALINE CONDITION OF 7.4 to 7.6.
A low pH will be corrosive to metals in the spa equipment. A high
pH will cause minerals to deposit on the interior surface (scaling);
in addition, the ability of the sanitation agents to keep the spa
clean is severely affected as the pH moves beyond the ideal range.
With CLEARRAY
pH
Free Chlorine no less than 1.0 ppm
Free Bromine no less than 2.0 ppm
Total Alkalinity 100-120 ppm
Calcium Hardness 150-250 ppm
IMPORTANT: CLEARRAY™ Water Purification System is facto-
ry installed. If the CLEARRAY™ system is altered or is not operat-
ing efficiently then follow the "without CLEARRAY™" water chem-
istry parameters.
CLEARRAY™ requires an annual lamp replacement to properly
sanitize your water.
Sanitizing
To destroy bacteria and organic compounds in the spa water, a
sanitizer must be used regularly.
27
Without CLEARRAY™
7.4-7.6 7.4-7.6
3.0-4.0 ppm
2.0-4.0 ppm
100-120 ppm
150-250 ppm