Spa Maintenance - Jacuzzi J-315 Montageanweisung Und Bedienung Und Wartung

rized use of the spa). In this mode, the skimming/heating
mode continues to operate as programmed. The temperature
display flashes when this function is enabled. Example: the
"F3" skimming/heater cycle was enabled prior to choos-
ing lock mode. The spa continues to perform the "F3" cy-
cle until lock mode is cancelled, allowing another cycle to
be selected.
I
To set the time of the first skimming/heating cycle connect the
spa to the power supply two minutes before the desired time.
EXAMPLE: If you desire your first skimming/heater cycle to begin
at 10:00 AM turn off power to the spa and turn it back on again at
9:58 AM.

Spa maintenance

Proper and regular maintenance of your spa will help it retain
its beauty and performance.
I
Cleaning the filters
Your Jacuzzi ® Premium spa is equipped with a skimmer and two
high-performance filter cartridges located inside the skimmer.
Fine debris is filtered by the circulation pump drawing water
through the skimmer bag and circulation pump cartridge.
Larger impurities are filtered by the 2-speed pump drawing wa-
ter through the skimmer bag and main pump cartridge during
normal operation and at each skimming/heating cycle.
To ensure optimum performance, clean both cartridges once a
month.
Dispenser for water sanitation
At authorized Jacuzzi dealers, you can purchase a dispenser
where you can place products for water sanitation).
This dispenser must be placed in the filtering cartridge (reco-
gnizable by the grille cover on the compartment) connected to
the circulation pump.
The dispenser must always be removed (while wearing latex
gloves) along with its cover during cleaning of the filter, and
is to be reinstalled when this operation is complete.
ALWAYS TURN POWER TO SPA BEFORE CLEANING
THE FILTER CARTRIDGES!
Refer to the filter cleaning/replacement procedure below:
B
E
A. Turn off power to spa.
B. Lift upward on filter cover handles to unsnap and remove it
from the retainer clips.
C. Remove skimmer bag from clips, clean out, then reinstall in
the filter cover.
D. Rotate each filter cartridge handle counter clockwise to re-
move them from their housing.
E. Remove both filters cartridges from skimmer well.
F. If present, first remove the dispenser for water sanitation, as in-
dicated above. Rinse impurities from the folds in the filters in each
cartridge with pressurized water. Start at top and work downward
to the handle. Repeat until all folds are clean.
G. Submerge both filter cartridges in spa. Tilt threaded end up-
ward to removed trapped air bubbles from each cartridge, then
keep both cartridges submerged.
H
H. Place each cartridge back into skimmer well, then rotate each
26
D
C
F G
J
I