10 Operating the model helicopter
h) Modifying the steering directions
Your remote control is tuned ex works exactly to your double rotor electric powered helicopter.
However, if during trimming, you notice that your model helicopter, with individual steering functions,
responds contrary to the pattern, then you can switch over at the transmitter, for each individual steering
function, the direction of the response of the model.
For this purpose, there are four reverse switches on the front of the transmitter. The switches are assigned
the following functions:
Switch
1
2
3
4
To switch over a steering function, first disconnect the flight battery in the helicopter, then switch off the
transmitter and
push the corresponding reverse switch in the other switch position.
Now you can switch on the transmitter again, connect the flight battery and check the correct function direc-
tion at thehelicopter.
Function
Tail-Function
Pitch-Function
Nick-Function
Roll-Function
Switch position
NOR
REV
NOR
REV