Introduction - Fermax DIGITAL Bedienungsanleitung

INTRODUCTION

The FERMAX DIGITAL KIT is an advanced Video Door Entry professional
system for simplified installation (no call wires), specially designed to be installed
in bungalows or small residential complexes. It is basically made up of an Outdoor
Panel, which is installed outside the house, and a Monitor, installed inside.
Moreover, the corresponding Power Supply must be installed in an inner place.
VERY IMPORTANT NOTES:
Pag 26
The Outdoor Panel is protected against humidity
and atmosferical agents. In adverse conditions with
permanently hard rain or salty environment, it is
recommended to install the Panel with a hood or under
shelter. Strong light coming straight into the camera
(against the light) will produce contrast and/or
brightness losses.
To install the Monitor, choose a hard and flat
surface, far away from direct heat sources (radiators,
heaters, ...) or very smoky environments (kitchens,
etc.). We advise to install the Monitor in a place where
the call could be heard all inside the house.
The Power Supply should be installed on a hard
and flat surface, as inside the buiding as in the lobby,
etc... but always in inner places. It can be installed in
a DIN box for electric switches.
Before installing the DIGITAL KIT, install the
cables needed to Monitor (or monitors), Outdoor
Panel and Power Supply, following the installation
diagram.