Cleaning And Maintenance; Troubleshooting - Concept PC5050 Bedienungsanleitung

EN

CLEANING AND MAINTENANCE

Turn the unit off, unplug the power cord from the wall outlet, and let the unit cool before cleaning and after use.
The unit and its accessories can be cleaned with a wet cloth.
Wash the replaceable parts in tepid water with detergent and rinse in clean water.
Do not immerse the baking pan in liquids. Just wash the inside with warm water with detergent and then rinse with
clean water. Clean the outer surfaces with a wet cloth.
Do not use steel wool, abrasive agents or solvents to clean the unit.
POSSIBLE PROBLEMS DURING BAKING
Problem
Bread has risen too much.
Bread has risen too much, then
collapsed.
Bread has not risen enough.
Crust is not well done.
Crust is brown on the sides, but
the crumb is not well done.
Sides and top of the loaf are
dusted with flour.

TROUBLESHOOTING

Problem
Cause
The ventilation grille emits
smoke during baking.
Bread can hardly be removed.
After pressing START/STOP
button "H:HH" is displayed.
PC5050
Use a lower volume of ingredients and keep the dosage ratio.
Too little flour, too much yeast, too much water, or water is too hot.
Too much flour, too little yeast, too much water, not enough sugar, poor
quality of flour, water is too cold, unsuitable program. Keep the dosage ratio.
Program has been suspended for too long, frequent opening of the lid, too
much yeast, poor quality of flour, unsuitable program.
Too much water.
Too much flour, not enough water.
Cause
Solution
The mains outlet is not live.
The unit starts pre-heating
when program is launched.
Some ingredients or impurities
are in the heater.
Dirty kneading blade can't be
taken from the spindle.
Temperature in the baking area
is too high, e .g. after previous
baking.
Cause
Solution
Check the plug connection.
Check for voltage, e.g. by connecting
another appliance.
This is a normal function. This is not
a defect.
Disconnect the cable from the socket.
Let the unit cool. Clean the heater.
After you remove the loaf, pour water in
the baking pan, let the kneading blade
soak, then clean it. Before mounting,
lubricate the spindle with edible oil or fat.
Disconnect the cable from the socket.
Open the lid, remove the baking pan, and
let the unit cool.
49