Technical Data; General Power Tool Safety Warnings; Work Area Safety - Parkside PFBS 160 B2 Originalbetriebsanleitung

Technical data

Rated power
consumption:
Rated voltage:
Rated speed:
Drills :
Discs:
Protection class:
Noise emission value:
Noise measurement value determined in accordance
with EN 60745. The rated noise level of the power
tool is typically as follows:
Sound pressure level:
Uncertainty K:
Sound power level:
Uncertainty K:
Wear hearing protection!
Vibration emission value:
Total vibration values (vector total of three direc-
tions) determined in accordance with EN 60745:
Vibration emission value: a
Uncertainty K = 1.5 m/s
NOTE
► The vibration level specified in these instruc-
tions has been measured in accordance with
a standardised measuring procedure and can
be used to make equipment comparisons. The
specified vibration emission value can also
be used to make an initial exposure estimate.
PFBS 160 B2
160 W
230–240 V ~ , 50 Hz
(AC)
n 10,000–40,000 rpm
max. Ø 3.2 mm
max. Ø 25 mm
II / (double insulation)
L = 75 dB(A)
PA
K = 3 dB
PA
L = 86 dB(A)
WA
K = 3 dB
WA
= 3.1 m/s 2
h
2
WARNING!
► The vibration level varies depending on the
use of the power tool and may be higher
than the value specified in these instructions
in some cases. Regular use of the power tool
in this way may cause the user to underesti-
mate the vibration. Try to keep the vibration
loads as low as possible. Measures to reduce
the vibration load are, e.g. wearing gloves
and limiting the working time. Wherein all
states of operation must be included (e.g.
times when the power tool is switched off and
times where the power tool is switched on but
running without load).
General Power Tool
Safety Warnings
WARNING!
► Read all safety warnings and all instructions.
Failure to follow the warnings and instruc-
tions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool.

1. Work area safety

a) Keep work area clean and well lit. Cluttered
or dark areas invite accidents.
b) Do not operate power tools in explosive atmo-
spheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control.
GB │ MT │
57 ■