Operation; Changing/Inserting The Tool/Collet Chuck; Whet Stone; Fitting Abrasive Belts - Parkside PFBS 160 B2 Originalbetriebsanleitung

Operation

Changing/inserting the tool/collet
chuck
♦ Press the spindle lock
♦ Turn the tensioning nut
into place.
♦ Undo the tensioning nut
using the combination spanner
♦ Remove any attached tool.
♦ First push the intended tool through the tensioning
nut before inserting it into the appropriate
collet chuck for the tool shaft.
♦ Press the spindle lock
♦ Push the collet chuck
and screw the tensioning nut
combination spanner
Using an accessory tool with a mandrel:
♦ Use the screwdriver side of the combination
spanner to undo and tighten the screw on
the mandrels or
♦ Insert the respective mandrel
the appliance as described.
♦ Use the combination spanner
screw on the mandrel
♦ Insert the desired accessory tool between the
two washers on the screw.
♦ Use the combination spanner
screw on the mandrel
│ GB │ MT
■ 64
and hold it down.
until the lock clicks
from the thread
.
and hold it down.
into the thread insert
tight with the
.
.
, or into
to undo the
or .
to tighten the
or .

Whet stone

♦ Do not manually grind any edges with the whet
stone .

Fitting abrasive belts

♦ Push the abrasive belt
mandrel . Tighten the screw on the abrasive
belt mandrel in order to fix the abrasive belt
.

Fitting polishing attachments

♦ Screw the polishing attachment
of the mandrel for polishing attachments
Switching on and off/setting speed
range
CAUTION!
■ The rotation direction can be read off the
arrow engraved on the union nut
clockwise symbol).
Switching on/setting the speed range:
♦ Set the ON/OFF switch
♦ Set the infinitely variable speed control
a position between "1" and "MAX".
Switching off:
♦ Move the ON/OFF switch
"O".
onto the abrasive belt
onto the tip
.
(anti-
to the "I" position.
to
to the position
PFBS 160 B2