Pyramis ecoline Installations- Und Gebrauchsanleitung Seite 36

COOKING TEMPERATURE ADJUSTMENT
Temperature can be adjusted at any function other than lamp and defrost (The default
Temperature will be shown on the Temperature Display). If not in any adjustment mode, the navigator
knob functions as a Temperature Adjustment Knob. Turning the knob left to decrease or right to
increase, adjust the Temperature between 40-250°C. The adjusted value will be shown on the
Temperature display. In case of changing the cooking function (by rotating the cooking function
selector), the setting will be cancelled and the default Temperature of the new function will be shown
on the display.
MANUAL COOKING
Once a function is selected, cooking starts immediately and the default Temperature assigned to
this function (if any) - shown on the Temperature Display - will be valid setting on the temperature
display (if any). Cooking will continue until the cooking function selector is brought to any of 0 (off), 1
(lamp) or 2 (defrost) positions. Maximum allowed cooking duration is 10 hours, Exceeding this
duration will result in an Error indication (See. Error Indications).
AUTOMATIC COOKING
Automatic cooking means, that cooking will end automatically according to the set parameters.
HALF AUTOMATIC COOKING
Cooking will start immediately and goes on for the duration programmed.
1. Select the desired cooking function and adjust (if needed and allowed) the temperature as
described before in this document.
2. Push and hold the navigator knob for 3 seconds until
3. Adjust the desired cooking duration by turning the navigator knob left to decrease or right
to increase.
4. After a few seconds, the flashing
FULL AUTOMATIC COOKING
This method is used when you want the food to be ready at a certain time in the future, given
that the cooking duration is programmed beforehand. Therefore, this method is also called 'Delayed
Cooking'.
1. Go through steps 1 to 3 of half automatic cooking (setting the cooking duration).
2. Push and release the navigator knob,
3. Adjust the desired end time by turning the navigator knob left to decrease or right to
increase.
delayed cooking is programmed and cooking has not started yet.
4. After a few seconds screen will stabilize, flashing will stop, adjustment is completed.
Note: Half and Full Automatic Cooking is only possible when no meat probe is connected.
symbol appears on the timer display.
symbol will disappear whereas
34
symbol starts flashing.
symbol will disappear, adjustment is completed.
symbol starts flashing.
symbol is still there, indicating that a
5