Editing The Design - Singer SE300 Montageanleitung

E
DITING THE
Before you begin embroidering, you can edit designs, as
shown below, using the Edit Tabs.
NOTE:
A pop up message may appear if you did not attach the correct
hoop.
✓
or change hoop size setting at the Embroidery Option screen
EMBROIDERY PLACEMENT SCREEN
embroidery design, as follows:
1. Press the Embroidery Placement tab.
2. Press the four arrow buttons to move the position.
a: up, b: left, c: right, d: down
The hoop will move according to the direction selected.
Each time the button is touched, the hoop will move. If the
button is touched and held, the movement will be done in
larger increments.
distance from center position.
NOTE:
The left side of screen is showing the embroidery area and
relative design position and size.
your editing.
1
D
ESIGN
2
b
c
d
e
EMBROIDERY ROTATION AND
MIRRORING SCREEN
1. Press the embroidery rotate and mirroring tab.
2. Press the Rotate button. By pressing this button, the design
will rotate 90 degrees clockwise. If the design is too wide or
too high to rotate 90 degrees, it will rotate 180 degrees.
The total rotation value will be indicated at the top right of
the LCD screen. Located to the left of the rotation value is
changed.
3. Press the Mirror buttons.
a. Mirror from top to bottom
b. Mirror from side to side
will change to the selections made, indicating the new
orientation of the embroidery design.
1
EMBROIDERY SCALING SCREEN
The design will be scaled 5 percent each pressing on a
button.
The maximum scaling is +/- 20 percent.
If scaling is exceeding the hoop size, it cannot be selected.
The value of the current scale is indicated between the
buttons, and size of scaled design is indicated on the top
line of screen.
49
2
3
b
2
b
c
1