Embroider A Design - Singer SE300 Montageanleitung

tab to start sewing.
STITCH OUT SCREEN
will appear.
design.
By pressing -/+ buttons, stitch will go backward/forward.
Press and hold will increase stepping speed.
c. Current color / Total number of colors
By pressing -/+ buttons, color block will go backward/
forward.
START TO SEW
CAUTION
2. Pass the upper thread through the hole of the embroidery
foot from the top side.
3. Lower the presser foot lifter.
4. Hold the upper thread.
carriage and the hoop.
1
4
2
b
c
A
8. When embroidering a color block is completed, machine
3
9. When the entire embroidery is completed, your machine
52
E
MBROIDER A
design.
NOTE:
If presser foot lifter is raised at this time, the pop up
button.
automatically after few stitches for cut thread end. A pop up
appears asking you to cut thread end. Cut thread end and
✓
will stop automatically and cut upper thread.
A pop up will appears asking you to change color. Re-
Each color segment is tied of at the end and the upper and
bobbin threads are cut.
cuts both threads and stops.
✓ button.
Raise the presser foot and remove the hoop.
9
D
ESIGN
✓
✓