Tracing; Monochrome - Singer SE300 Montageanleitung

EMBROIDERY OPTION SCREEN
1. Press the Embroidery Option tab.
buttons, as shown below:
B. Tracing
C. Basting
D. Monochrome
H O S
OOP PTION AND
The top right button shows the hoop size selected. Press this
button to select a hoop position or to change the hoop size.
2
A
B
C
D
1
( )
ELECTION A
A
E
DITING THE
HOOP OPTION - SELECT HOOP POSITION
i. Current Position:
When you want to return to the current stitch and start
embroidering again where the embroidery was interrupted,
press this button.
Hoop will move to current positon and return to embroidery
option screen.
NOTE:
positon and Embroidery Option screen.
ii. Cut Position:
By pressing this button, move the hoop towards you,
making it easier to trim fabric when embroidering an
iii. Park Position:
your machine, it will be necessary to move the hoop
carriage to Park position. Press the Park position button.
✓
the correct position for storage.
Then, turn off the power switch and remove the unit.
NOTE:
It is very important that the hoop is removed, otherwise it
may be damaged.
iv. Center Position:
If you want to check where the center position of the hoop
will be placed on the fabric, press this button.
iii
NOTE:
50
D
ESIGN
✓
i ii