Inserting The Bobbin - Singer SE300 Montageanleitung

W B I
INDING OBBIN NDEPENDENTLY
1. Insert the auxiliary spool pin into the hole at the left side on
the top of the machine.
2. Place the felt washer and spool of thread onto the auxiliary
spool pin.
3. Bring thread to the right and hook the thread to the thread
guide from rear opening.
T
HREADING THE
I B
NSERTING THE OBBIN
1. Place bobbin into bobbin case, making sure the bobbin
turns in a counter-clockwise direction.
3. Pull thread along the groove, up and around the top, to the
left, then down.
Pull thread to the right to cut the thread.
needle plate and push the right side of bobbin cover down
until it clicks into place.
NOTE:
This machine can start to sew without drawing up the bobbin
thread.
If you want to draw up the bobbin thread, see page 20.
this machine.
18
M
ACHINE