Singer SE300 Montageanleitung Seite 23

S T
TARTING O
T S
ACK TITCH
stitch.
1. Press the Tack button. LED light will be turned on.
Machine will sew tacking stitches and stop automatically.
4. When you reach the end of seam, press the Tack button.
Machine will sew tacking stitches and stop automatically.
T C
URNING ORNERS
2. Turn the hand wheel toward you to insert the needle into
fabric.
NOTE:
Needle Up/Down button. When needle position is setted to
down, the LED will turn on.
needle.
3. Raise the presser foot.
4. Use the needle as a pivot and turn fabric.
5. Lower the presser foot and resume sewing.
S
EW
S H F
EWING EAVY ABRIC
When sewing heavy or thick fabrics, the toe end of the presser
foot tends to lift up when it comes to seams or other bulky
areas. To sew these heavy or thick fabrics:
1. When the toe of the presser foot begins to tilt up, lower the
needle into the fabric and then raise the presser foot lifter.
lifter. The presser foot should now be level on the thick
fabric.
release.
a. The presser bar lifter can be raised one step higher for
placing heavy materials under the presser foot easily.
S O
EWING OVER VERLAPPED
Guide the fabric with your hand when sewing over overlapped
areas.
W S A
IDTH OF EAM LLOWANCE
Guide lines on the needle plate indicate the distance from the
center needle positon. To keep a consistent seam allowance,
guide the fabric along the desired guide line on the needle
plate.
23
A
REAS