Twin Needle - Singer SE300 Montageanleitung

S P
EWING REPARATION
Upper thread will appear on the bottom side of the fabric.
Increase upper thread tension.
Thread tension should be set to a slightly looser tension than
that for straight stitch.
The upper thread should appear slightly on the bottom side of
your fabric, for example, when doing decorative sewing.
on the top side of the fabric are good, but the bottom side
is not threaded correctly. Refer to page 19 for correct
threading.
2. If after checking the top thread and the bobbin thread is still
showing on the top side, check the bobbin to see if it is set
correctly. Refer to page 18 for information on correct bobbin
setting.
T N
WIN EEDLE
Activate the twin needle program by pressing - or + buttons
to set the twin needle width. When a twin needle width is
selected, the width of all stitches is limited to prevent
needle breakage.
To deactivate, press - button until number of twin needle width
will disappear.
In sewing mode, the Twin Needle icon will be shown. The
setting is kept until you deactivate it.
This pop-up message will appear when Twin
Needle program is activated.
continue.
This message will appear when a stitch that
cannot be used with twin needle, is selected.
✓" button and select another
pattern or reset the twin needle program.
This message will appear when stitch width is
adjusted to the limit.
✓" button to continue.
15
✓" button to