Maintenance; Cleaning; Bobbin Holder - Singer SE300 Montageanleitung

DANGER
To reduce the risk of electric shock, disconnect the

CLEANING

If lint and bits of thread accumulate in the hook, this will
interfere with the smooth operation of the machine. Check
regularly and clean the stitching mechanism as needed.
NOTE:
* An LED lamp is used to illuminate the stitching area. It does
* There is no need to lubricate this machine.
B H
OBBIN OLDER
Remove the bobbin cover and bobbin.
Clean the bobbin holder with a brush.
H R F
OOK ACE AND EED
1. Remove the needle, presser foot and holder. Remove the
bobbin cover and bobbin. Remove the screws holding the
needle plate.
2. Remove the needle plate by lifting up the right side of the
plate.
1
D
OG
2
M
AINTENANCE
3. Lift up the bobbin holder and remove it.
CAUTION
4. Clean the hook race, feed dogs and bobbin holder with a
brush. Also clean them, using a soft, dry cloth.
3
5. Replace the bobbin holder into the hook race so that the tip
6. Replace the needle plate inserting the hook into the
machine.
Replace the screws and tighten.
b
c
56
4