Power Board Replacement - Bosch WBE 4200 Instandsetzungsanleitung

en 52 | WBE 4200 | Replacement interventions
Fig. 19: Belt replacement
4. Remove the belt of the motor by loosening the three
side screws (fig.21, pos. 1) and the screw (fig.21,
pos.2) in order to loosen the belt;
i
Adjust the tension of the belt (by tightening the
adjustment screw) until it possible to manually
rotate by 90°.
"
Belt tensioning check.
|
1 695 600 091 2012-11-16
8.4

Power board replacement

1. Remove the weights protection;
2. Loosen the 5 rear screws using an allen wrench;
Fig. 20:
3. replace the board and restore connections.
Fig. 21:
1. CN3 - Protection micro switch
2. CN4 - CPU cable
3. CN5
4. F1=500 mAT
5. F2=450 mAT
Robert Bosch GmbH