37 8.2 Replacement Easyfit® Calliper; 37 8.3 Engine Belt Replacement - Bosch WBE 4200 Instandsetzungsanleitung

8.2 Replacement Easyfit® calliper
1. Remove the weights protection;
2. Disconnect the Control panel;
3. Loosen the fixing screw of the feeler (fig.15, pos.1);
Fig. 14:
4. Extract the entire Easyfit® calliper unit from the
machine;
Fig. 15:
5. Replace the calliper unit
6. Reassemble it following the same disassembling
procedure.
Robert Bosch GmbH
Replacement interventions | WBE 4200 | 51
8.3 Engine belt replacement
1. Remove the weights protection;
2. Remove the central centring flange (fig.20, pos.1)
and, once loosened the three screws (fig.20, pos.4)
and the two screws (fig.20, pos.2);
Fig. 16:
Fig. 17:
Fig. 18:
3. Remove the pin cover in fig.20,pos.3 and the side
cover of the motor closing in fig.20, pos. 5;
en
|
1 695 600 091 2012-11-16