Wbe 4200 - Bosch WBE 4200 Instandsetzungsanleitung

en 38 | WBE 4200 | User information
3.3

WBE 4200

Fig. 1: WBE 4200
Item Designation
1 Control panel
2 Vernier caliper (electronic)
3 Wheel guard, moving
4 Pedal
5 Tray
6 On/off switch
7 Clamping tool holders
8 Mains socket
9 Connection for angular width gauge*
10 Quick-action clamping nut
11 Centering flange with tie rod
12 Centering cone
13 Manual vernier caliper
14 Balance weight pliers
15 Measuring compasses
16 Concave sleeve
17 Spacer ring
18 Rubber guard ring
19 Plastic spatula
* special accessories
|
1 695 600 091 2012-11-16
Function/purpose
Operation of WBE 4200
R Recording of rim distance and rim diameter.
R Determination of positions for attachment of adhesive weights.
R Protection of operator against flying particles (e. g. dirt, water).
R Starting and stopping measurement.
Blocking of wheel for attachment or removal of balance weights.
For storing balance weights and accessories.
Switching WBE 4200 on and off
Storage of accessories
Connection for power cord.
Connect the angular width gauge to the machine.
Centering and attachment of wheel on cone
Wheel attachment.
Centering of wheel on flange shaft.
Can be used as substitute if the electronic vernier caliper is defective.
For attaching balance weights to rim and removing weights.
Can be used as substitute if the rim width and rim diameter cannot be recorded
electronically.
For use with quick-action clamping nut and for external attachment of centering
cone.
For use with quick-action clamping nut and aluminum rims..
For use with quick-action clamping nut and aluminum rims.
For removing adhesive weights
Robert Bosch GmbH