Firmware Updating Procedure; Calibration; Flange Calibration; Calibrating The Electronic Vernier Caliper - Bosch WBE 4200 Instandsetzungsanleitung

GLR ANG
2)
LIN
FST On
OFF
ILL* On
OFF
BRA* On
OFF
1) Function only available with gauge arm for measuring rim width
fitted and activated.
*)Option not available for WBE 4200
NOTES FOR THE ASSISTANCE:
Here you are the settings belonging to the WBE 4200
version:
Left Display
POT
ALU
FLA
PLR
GLR
FST
ILL
BRA
5.2.1

Firmware updating procedure

The new generation of boards introduced by Sicam
works in Windows CE; this enables our research and
development department to constantly update the
machines, in order to resolve any programming errors
and to add functions to the machine, like translations in
different languages and special programmes.
i
The updates are sent via PROGUSB.
i
To use the device, see the manual specific.
i
Repeat machine calibration after updating.
i
Current software version can be seen on EDIS\
SOFTWARE\SYSTEMSW\WB ("WB" stands for the
wheel wheel balancing machine model designation)
or ask Technical Support.
Robert Bosch GmbH
Activate/Disactivate angular
width calibration (An6) or the
length measuring arm (Lin)
Activate/Disactivate the quick
measurement cycle
Internal illuminator activation/
deactivation
Electro-magnetic brake
activation/deactivation
Right Display
On
On
OFF
OFF
Lin
On
OFF
OFF
Menu navigation | WBE 4200 | 41
5.3

Calibration

Press <MENU> until the notice <CAL> is shown and
then press <OPERATOR>.
R
<MENU> - SET - CAL - <OPERATOR>
5.3.1

Flange calibration

Left Display Right Display
C-1
C-2
5.3.2

Calibrating the electronic vernier caliper

Left Display Right Display Description
D-1 0 or higher
D-2 200
H-1 ex.: 15"
C-2
5.3.3

WBE 4200 calibration

Left Display Right Display Description
C-2
C-3
C-4
C-5
Description
Memorization of the zero group
flange and shaft
Setting up of the wheel size and
memorization of the unbalance
Calibration of the distance
potentiometer: position of rest
Calibration of the distance
potentiometer: position at 20cm
Calibration of the diameter
potentiometer
Setting up of the wheel size and
memorization of the unbalance
Setting up of the wheel size and
memorization of the unbalance
Setting up of the calibration
weight and launch with the weight
inside
Launch with the weight outside
Adjustment of the angle
|
1 695 600 091 2012-11-16
en