Stryker 5050 Bedienungsanleitung Seite 7

• Do not allow fluid to pool on the mattress. Fluids can cause corrosion of components and may cause the safety and
performance of this product to become unpredictable.
• Always inspect mattress covers for tears, punctures, excessive wear, and misaligned zippers every time you clean the
covers. Remove and replace a damaged mattress to prevent cross-contamination.
• Do not steam clean, pressure wash, hose off, or ultrasonically clean mattresses. These methods of cleaning may void
the product's warranty.
• Do not steam clean, hose off, or ultrasonically clean the product. Use of these methods of cleaning is not recommended
and may void the product's warranty.
• Always disinfect the mattress between patients. Failure to do so could result in cross-contamination and infection.
C C A A U U T T I I O O N N
• Improper usage of the product can cause injury to the patient or operator. Operate the product only as described in this
manual.
• Do not modify the product or any components of the product. Modifying the product can cause unpredictable operation
resulting in injury to patient or operator. Modifying the product also voids its warranty.
• Always remove any devices that may be in the way before you raise or lower the litter.
• Do not raise the product (hydraulics on base) with a patient lift under the product.
• Always support the foot section while repositioning to make sure that it does not fall. Patient or operator injury or device
damage may occur.
• The maximum PSI level for the drape support/oxygen tubing is 20 PSI (1.38 Bars/140 KPA).
• Do not use the IV pole as a push/pull device. Product damage may occur.
• Do not hang IV bags that exceed 40 lb (18 kg) on the IV pole.
• Always make sure that the IV pole is at a low height to pass through door openings when you transport a patient.
P P i i n n c c h h p p o o i i n n t t s s
5050-009-005 Rev B.0 3 EN