Placing The Bench Press Drill In A Suitable Working Position; Installation And Bringing Into Use; Checking The V-Belts - Parkside PTBM 500 Bedienungs- Und Sicherheitshinweise

Operation
bolt them together in the following order: Flat
a / retaining rings
washers
17
bolts .
17
j
Place the drilling table
slide it fully downwards and fix it in position
with the clamp bolt
j
Fasten the vice
13
the vice bolts / flat washers
20
The elongated holes allow the vice to be fastened
in different positions. This allows different sizes of
workpieces to be clamped.
j
Place the pre-assembled motor unit
the column . Secure the motor unit
23
tightening the two hexagon socket head bolts
31 at the side using the Allen key
j
Attach the three drill lifting arms of the handle /
spindle guide
7
j
Open the chuck
of the drill spindle
firmly and securely on to the cone of the drill
spindle lightly tap the chuck
4
with a plastic hammer.
30 GB/MT
E-3470_Table_Drill_PTBM500_Content_LB5.indd 30
b mounting
17
on the column
19 23
.
16
to the drilling table with
19
a / nuts
20 20
13
20
a
20
19
a
20
b
20
on to
24
by
24
30 .
.
and place it on the cone
3
. To attach the chuck
4 3
a few times
3
Insert the guard
it in place with the 3 bolts, retaining rings and
nuts in the mount.
, The bottom part of the guard can be adjusted in
height.
j
Release the wing bolts, bring the bottom part
of the guard into the desired position and then
b.
tighten the wing bolts again.
Placing the bench press drill in
Q
a suitable working position
j
Set the bench press drill down on a firm sur-
face and level it using a spirit level. We also
recommend that the machine is firmly bolted to
the supporting surface. Use the two holes in
the base plate
18
plate is not overstressed when bolted
18
down.
Installation and bringing into
Q
use
j
Check that the supply type, voltage and fuses
agree with those specified for the machine.

Checking the V-belts

Q
j
Unscrew the drive / belt cover locking screw
j
Open the drive / belt cover
sion of the V-belts
the V-belt can be squeezed in slightly.
28
into the mount and attach
5
for this. Ensure that the base
10
. Check the ten-
6
. It is correctly set when
28
17.03.2008 16:23:04 Uhr
.