Service
a) Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool is
maintained.
Hammer safety warnings
a) Wear ear protectors. Exposure to noise
can cause hearing loss.
b) Use auxiliary handle(s), if supplied
with the tool. Loss of control can cause
personal injury.
c) Hold power tool by insulated gripping
surfaces, when performing an oper-
ation where the cutting accessory may
contact hidden wiring or its own cord.
Cutting accessory contacting a "live" wire
may make exposed metal parts of the power
tool "live" and could give the operator an
electric shock.
d) Wear a dust mask.
Installation
Additional handle
Undo the knurled nut
Swing the additional handle
product axis or 180 ° forward or backward
into the desired position (see Fig.).
Retighten the knurled nut
Note: only use the tool with the additional
handle
.
4
Fitting a tool
Pull the locking sleeve
Insert the tool by twisting it into the tool holder
until it clicks into place.
7
Release the locking sleeve
holder. Pull the tool to ensure that it is firmly
locked in place. The tool has a radial clear-
ance which is determined by the system.
.
5
around the
4
.
5
back.
8
to lock the
8
Removing a tool
Pull the tool's locking sleeve
the tool out from the tool holder
Adjusting the chisel position
Insert the flat chisel
Bring the flat chisel
working position.
Push the chisel adjustment ring
Rotate the flat chisel
justment ring
into the required position.
6
Then, release the chisel adjustment ring
rotate it until it clicks in.
Start-up
Switching on and off
When operating the device you can choose be-
tween intermittent or continuous operation mode.
Intermittent operation mode:
To switch on intermittent operation mode, hold
the ON / OFF switch
To switch off intermittent operation mode,
release the ON / OFF switch
Continuous operation mode:
To switch on continuous operation mode, press
the ON / OFF switch
pressed using the lock
To switch off continuous operation mode, press
the ON / OFF switch
more.
You can use the chisel on concrete, brick, stone
and asphalt as well as to remove tiles and
flooring.
back and pull
8
.
7
into the tool holder
10
into the best possible
10
forward.
6
using the chisel ad-
10
and
6
.
3
.
3
and lock this while
3
.
2
and release it once
3
GB
.
7
9