Silvercrest SDD 1600 A1 Bedienungs- Und Sicherheitshinweise Seite 9

Allow the product to cool down
before moving it to a different
location.
The heating element is subject
to residual heat after use.
Pull the mains plug after each
use.
Never let the supply cord hang
down over the edge of the work
surface so that the product can-
not be pulled down accidentally.
Let the product completely cool
down, before you remove the
remaining water from the main
unit or drip tray
12
Only use clean drinking water
to generate steam.
ATTENTION! HAZ-
ARD OF FIRE! Do not
operate the product in the prox-
imity of or below curtains, wall
cupboards or other inflamma-
ble materials.
Place the product on a heat
resistant surface (no varnished
tables, no table cloths). Do not
operate it in the vicinity of other
sources of heat (oven, gas
flame). Otherwise, the product
and / or pieces of furniture may
be damaged.
Place the product on an even,
stable surface at a safe dis-
tance to walls and cupboards
.
9
in order to avoid any damage
caused by steam rising.
Always fill the water tank
with sufficient water for the peri-
od of steaming. Do not cover
the main unit
12
with aluminium foil or any other
material. If not observed, this
can lead to an overheating of
the product. Damage of the
product is the consequence.
Ensure the water level is be-
tween minimum and maximum
marking. Do not overfill the
product otherwise hot water
may be ejected.
Never operate the product with-
out water in the water tank
Never immerse the main unit
in water and always pull the
mains plug before cleaning or
transporting it.
Avoid using extension cables.
These may only be used under
very specific conditions:
- the extension cable must be
able to handle the amount of
current drawn by the product,
- the extension cable must not
be "suspended". Keep chil-
dren away from it and ensure
that it does not present a trip
hazard,
10
/ drip tray
9
.
10
12
GB 9