Before Use; Dividing Plate; Initial Setup - Silvercrest SDD 1600 A1 Bedienungs- Und Sicherheitshinweise

product. If liquid should enter
the product, unplug the mains
plug immediately and have the
product repaired by a qualified
technician.
Only use accessories and addi-
tional equipment stated in this
instruction manual. The use of
other products or accessories
than recommended in the in-
struction manual may present a
risk of injuries for you.
FOOD-SAFE! The
taste and smell of your
food are not detrimen-
tally affected by this
product.

Before use

Remove all packaging material before use.
It is important to clean the product before first
use or if it has not been used for a long peri-
od of time. See the "Care And Cleaning" sec-
tion for more information.
It is essential that the product is descaled at
regular intervals to maintain optimum steam
and extend the life of the unit. See the "Des-
caling" section for more information.
During the first use, you may notice some
smoke / vapour emitting from the rear of the
main unit . It is normal as grease is usually
12
applied on some parts of the product during
the manufacturing process. After serval use of
the product, it will no longer occur. This is not
dangerous and will not contaminate or fla-
vour food during use.

Dividing plate

The top / bottom containers
separated into two compartments each with
the dividing plates
5
the dividing plate
5
rails.
To setup a larger single steaming compart-
ment, remove the dividing plates
the top/bottom containers
Note: The dividing plate (square shape, for
bottom container)
7
one direction. Ensure both locking tabs
gage both holes on the bottom container
33

Initial setup

Check and ensure that the mains voltage of
the mains power socket is according to the
"Technical Data" section.
Place the main unit
12
surface.
Fill the water tank
10
maximum level (see Fig A and G).
Note: The water tank
with water at least up to the MIN mark
ATTENTION! HOT SURFACE!
Make sure that the water does not
exceed the MAX mark
wise, hot water may spurt out of the product
during operation.
ATTENTION! Do not add anything like sea-
sonings etc. to the water. This may affect the
steam flow and / or damage the surface of
the water tank and the heating element.
10
First place the drip tray
, ensure the tongues
12
the slots .
35
Then place the bottom container
serted dividing plate
Now place food in the compartment of bot-
tom container . Use the dividing plate
8
to ensure food do not mix.
If necessary, put the top container
bottom container
8
/
5 7
/ can be
6 8
/ . To do so, place
7
/ into the designated
7
/ from
5 7
/ .
6 8
can only be inserted in
en-
32
8
on a stable, even
with cold water to the
has to be filled
10
.
14
. Other-
15
onto the main unit
9
are aligned with
34
with in-
8
onto the drip tray
7 9
7
on the
6
, place food in the
GB
.
.
11