Erasing Service Data; Save Initialization Data - axing SKM 40-00M Betriebsanleitung

Operation instructions | SKM 40-00M | SKM 40-04M | SKM 80-00M
 Click on REBOOT.
After rebooting, the password must be entered again.
Note: If SAT signals are temporarily unavailable (e.g. due to snow), the module will reboot every 10 minutes.
This ensures that all configured programmes will be available once the signal becomes available again.
3.7.5.

Erasing service data

In the section ERASE SERVICE DATA you can erase the settings from phase 2. The transponder data must be
read again for tuners 1-4 by executing a scan.
The module is also set to remux mode.
 Click on erase.
The frontpage will be shown.
3.7.6.

Save Initialization Data

In the section SAVE SYSTEM INITILIZATION DATA TO FILE you can save the current initilization data from phase
1 to 3 into a file on your computer.
 Click on SAVE.
The data will be saved in a file called config.dat at the download folder on your computer.
 Click on PDF TO PRINT.
A PDF will be generated and saved in a file called config.pdf at the download folder on your computer.
Note: Password and IP adress will not be saved.
34 2020-02-23 | Technical improvements, changes in design, printing- and other errors expected.