Using Ci Menu; Decryption Of Programmes - axing SKM 40-00M Betriebsanleitung

Operation instructions | SKM 40-00M | SKM 40-04M | SKM 80-00M
4.2.1.

Using CI menu

The content of the CI menu depends on the CAM manufacturer and the card being used. Depending on the
manufacturer, various settings are possible. Information on validity and authorisation are the most important.
 Please observe the operating instructions provided by the manufacturer.
Cursor position
According to used CAM different settings can be done. Most important is getting information about
authorisation.
The input and navigation field is used for navigation within the CI menu.
 Use Up or Down to reach a higher or lower selection point.
 Use Ok to enter a corresponding sub menu or confirm a selection.
 Use Menu to come back to the next superordinate level.
 Use Exit to leave the menu.
4.3.

Decryption of programmes

Scrambled programs are indicated by the abbreviation CA in the column Encryption of the tuner table.
By default, encryption is disabled. The program will be transferred to the modulator in encrypted form and
must be decrypted in the receiver.
If CA modules are plugged in the headend module, the corresponding programs can be decrypted.
 Activate the option in the column Decrypt.
The dot next to the check mark shows the status:
•
light grey = state unknown, decryption is proofen
•
green = program is decrypted
•
dark grey = No subscription available for the program
•
red = encrypted
44 2020-02-23 | Technical improvements, changes in design, printing- and other errors expected.
The Content depends on used
CAM
Input and navigation field
Activate the
decryption