Safety Instructions - axing SKM 40-00M Betriebsanleitung

Operation instructions | SKM 40-00M | SKM 40-04M | SKM 80-00M

Safety instructions:

•
The installation of the device and repair work on the device must be carried out only by a professional
in accordance with the applicable VDE directives. In case of incorrect installation, no liability is
assumed.
•
Never open the device. There are no parts to be maintained by the user inside the device, however,
lethal voltages are present. This also applies to cleaning the device or working on the connections.
•
It is imperative to use a power supply unit with sufficient output power for your application!
•
Use only the mains cable enclosed to the device. Never replace any parts or make any modifications
to the mains cable. Otherwise, there is a risk of death.
•
If you intend not to use the device for a longer period of time, we recommend you to completely
disconnect the device from the mains for safety reasons and for saving energy by pulling out the
mains plug.
•
Let the device adjust to the room temperature before commissioning, in particular if condensation is
present on the device, or if it was exposed to large temperature fluctuations.
•
The device must be operated only in moderate climate.
•
The device must be operated only in dry rooms. In damp rooms or outdoors, there is a risk of short-
circuits (attention: risk of fire) or electrical shocks (attention: risk of death).
•
Plan the mounting or installation location such that you can easily reach the mains plug and interrupt
the electric circuit in dangerous situations. Select the mounting or installation location such that
children cannot play near the device and its connections without supervision. The mounting or
installation location must allow a safe installation of all connected cables. Power supply cables and
supply cables must not be damaged or squeezed by any objects.
•
Operate the device only on a flat, firm surface and protect it against unintentional movements.
•
Never expose the device to direct solar irradiation and avoid direct vicinity of heat sources (e.g.
heaters, other electrical appliances, fireplace, etc.). It must be always ensured that devices with
cooling elements or ventilation slots are not covered or obstructed.
•
Ensure generous air circulation around the device. This will prevent possible damage to device and
risk of fire due to overheating. It must be always ensured that cables are not located near heat
sources (e.g. heaters, other electrical appliances, fireplace, etc.).
•
For 19-inch rack mounting, there must be at least 5 cm clearance in front of and behind the unit.
•
In particular, the warranty and liability shall be excluded for the consequences of incorrect use, in
case of incorrect modifications or repair work carried out by the customer. Use the device only as
described in the operating instructions and in particular according to the state-of-the-art.
•
The antenna system must be installed and grounded according to the current DIN EN 60728-11
standard.
Herewith AXING AG declares that the marked products comply with the valid guidelines.
You can call up the complete EU declaration of conformity for download by entering the
article in the search field at www.axing.com.
WEEE Nr. DE26869279 | Electrical and electronic components must not be disposed of
as residual waste, it must be disposed of separately.
4 2020-02-23 | Technical improvements, changes in design, printing- and other errors expected.