Config; Erasing Service Data; Save Initialization Data; Upload Initialization Data - axing SKF 42-00 Betriebsanleitung

Operation instructions | SKF 42-00 | SKF 82-00
4.3.

Config

4.3.1.

Erasing service data

In the section ERASE SERVICE DATA you can erase the settings from phase 2. The transponder data must be
read again executing a scan.
è Click on ERASE.
The frontpage will be shown.
4.3.2.

Save Initialization Data

In the section SAVE SYSTEM INITILIZATION DATA TO FILE you can save the current initilization data from phase
1 to 3 into a file on your computer.
è Click on SAVE,
the data is offered to you for saving as a config.dat file
è Click on PDF TO PRINT,
a PDF is generated and offered as Config.pdf for opening or saving.
Note: Password and IP adress will not be saved.
4.3.3.

Upload Initialization Data

In the section UPLOAD SYSTEM INITILIZATION DATA FROM FILE you can upload the initiaization data from a
file to the modul.
èChoose a configuration file.
èClick on UPLOAD.
The upload will take a few seconds.
Page 18 of 24 AXING-BA_SKF-42-82-00.pdf | Technical improvements, changes in design, printing and other errors reserved. | 2021-12-13