Edit The Nit With Mks 1 - axing SKM 40-00M Betriebsanleitung

Operation instructions | SKM 40-00M | SKM 40-04M | SKM 80-00M
Select type
 Select Auto.
An NIT is created that contains all channels (from 114 MHz to 1002 MHz).
The unoccupied channels contain only the most important parameters such as symbol rate and
modulation.
 Select Off.
There is no NIT created and therefore no LCN output.
 Select Manual.
The input fields for reading, checking and uploading the NIT are displayed.
Note: Only with the software extension MKS 1-00 can the type be set to Manual and a Network
Information Table (NIT) be read from the devices, edited and uploaded back to the devices. The MKS 1-00
must be installed by AXING support (for this purpose, a connection with the Internet is necessary).

3.7.14. Edit the NIT with MKS 1

Read NIT
Under STEP 1: READ NIT (DVB-C) the devices in the network are displayed.
 Select the devices from which the NIT is to be read out.
The device you are currently configuring (This device) is always selected.
 Click on READ NIT.
The data of the devices are read in and listed under STEP 2: VERIFY NIT.
Note: If necessary, you must reset the NIT before importing (see „Reset the NIT" on page 42).
40 2020-02-23 | Technical improvements, changes in design, printing- and other errors expected.