Milling Direction; Milling Operation; Fitting The Copy Sleeve; Milling With The Copy Sleeve - Parkside POF 1200 D3 Originalbetriebsanleitung

Milling direction

The milling process must always be carried out
against the direction of rotation of the milling cutter
(reverse rotation) . ATTENTION: When milling in
the direction of rotation (synchronous running), the
power tool can be ripped out of your hand .

Milling operation

Adjust the desired milling depth as described
above .
♦ Place the appliance onto the workpiece and
switch it on .
♦ Release the clamping lever
clockwise and pushing the appliance down-
wards until the depth stop
stop .
♦ Lock the appliance by turning the clamping
lever anticlockwise .
♦ Carry out the milling process at a uniform speed
and contact pressure .
POF 1200 D3

Fitting the copy sleeve

♦
♦

Milling with the copy sleeve

You can use a copy sleeve
onto the workpiece .
♦
♦
♦

Milling with the rip fence

♦
♦
by turning it
sits on the step
Fit the copy sleeve
from below .
Fasten the copy sleeve
using the two screws
adapter .
Ensure that you insert the copy sleeve
right way around – the race
downwards (see fig . C) .
NOTE
► The template must be at least as high as the
race of the copy sleeve
► Select a smaller cutter than the inner diameter
of the copy sleeve .
Place the router with the copy sleeve on the
template .
Release the clamping lever
clockwise and lower the appliance until the
previously set milling depth is reached .
Now guide the appliance around the template
with the copy sleeve protruding . Do not exert
excessive pressure when working .
Push the rip fence
dimension into the guide rails
plate and tighten the locking screws
Place the rip fence
workpiece (see Fig . E) .
GB │ IE │ NI │ CY
into the skid plate
onto the base plate
of the dust extraction
the
must be facing
.
to transfer templates
by turning it
according to the required
on the base
.
onto the edge of the
│ 9 ■