Direction Of Feed; Routing Process; Setting The Guide Bushing; Routing With The Guide Bushing - Parkside POF 1300 Bedienungs- Und Sicherheitshinweise

j
Tighten the stop screw
again.
j
Release the clamping lever
clockwise and then guide the device back up
again. Check the depth of cut by carrying out
a further practical test.
Setting the depth of cut using the step
buffer
You can use the step buffer
depths of cut in several successive stages in which
less material is removed.
j
Set the required depth of cut with the lowest
step of the step buffer
above).
j
Afterwards the higher steps can be used for
the first few cuts.

Direction of feed

Q
m Danger! When machining with the direction
of rotation the router can be ripped out of your
hands. This may cause injury.
J
Always machine against the direction of
rotation of the router bit!

Routing process

Q
j
Adjust the depth of cut as described above.
j
Place the device on the workpiece and switch
it on.
j
Release the clamping lever
clockwise and press the device downwards un-
til the depth stop
10
for depth stop
9 10
by turning it
15
to make greater
7
(as described
7
by turning it
15
runs against the workpiece.
j
Lock the device by turning the clamping lever
anticlockwise.
15
j
Carry out the routing process using uniform
speed and pressure
j
Stop the routing process by lifting the device
from the workpiece and switching it off.

Setting the guide bushing

Q
j
Insert the guide bushing
guide plate .
6
j
Fasten the guide bushing
using the two screws
5
traction adapter. Make sure that the guide
bushing is the right way round - the guide
35
bushing ring must be facing downwards.
36

Routing with the guide bushing

Q
Note! When using the guide bushing, the template
must have a minimum thickness of 8 mm.
Note! The template must be at least as thick as
the guide bushing ring
Note! Choose a router bit with a smaller diameter
than the internal diameter of the guide bushing.
By using the guide bushing
templates or patterns on to the workpiece.
j
Place the device with the guide bushing
against the template.
j
Release the clamping lever
clockwise and lower the device until the previ-
ously set depth of cut is reached.
j
Now guide the device with the projecting
guide bushing along the template, whilst apply-
ing light pressure.

Routing with the guide fence

Q
j
Insert the guide fence
of the base plate
5
suit the required dimension using the locking
screw .
21
Operation
from below into the
35
to the base plate
35
of the vacuum ex-
30
of guide bushing
36 35
you can superimpose
35
by turning it
15
into the guide rails
27
and fasten it into place to
GB
.
22
15