Milling Direction; Milling Operation; Fitting The Copy Sleeve; Milling With The Copy Sleeve - Parkside POF 1200 D3 Originalbetriebsanleitung

Milling direction

The milling process must always be carried out
against the direction of rotation of the milling cutter
(reverse rotation). ATTENTION: When milling in
the direction of rotation (synchronous running), the
power tool can be ripped out of your hand.

Milling operation

Adjust the desired milling depth as described
above.
♦ Place the appliance onto the workpiece and
switch it on.
♦ Release the clamping lever
clockwise and pushing the appliance down-
wards until the depth stop
stop .
♦ Lock the appliance by turning the clamping
lever anticlockwise.
♦ Carry out the milling process at a uniform speed
and contact pressure.
POF 1200 D3

Fitting the copy sleeve

♦
♦

Milling with the copy sleeve

You can use a copy sleeve
onto the workpiece.
♦
♦
♦

Milling with the rip fence

♦
♦
by turning it
sits on the step
Fit the copy sleeve
from below.
Fasten the copy sleeve
using the two screws
adapter.
Ensure that you insert the copy sleeve
right way around – the race
downwards (see fig. C).
NOTE
► The template must be at least as high as the
race of the copy sleeve
► Select a smaller cutter than the inner diameter
of the copy sleeve.
Place the router with the copy sleeve on the
template.
Release the clamping lever
clockwise and lower the appliance until the
previously set milling depth is reached.
Now guide the appliance around the template
with the copy sleeve protruding. Do not exert
excessive pressure when working.
Push the rip fence
dimension into the guide rails
plate and tighten the locking screws
Place the rip fence
workpiece (see Fig. E).
into the skid plate
onto the base plate
of the dust extraction
the
must be facing
.
to transfer templates
by turning it
according to the required
on the base
.
onto the edge of the
GB │ MT │
51 ■