Technical Specifications; General Power Tool Safety Warnings; Work Area Safety - Parkside POF 1200 D3 Originalbetriebsanleitung

Technical specifications

Rated power input:
Rated voltage:
Rated no-load speed:
Max . operating speed
(milling cutter)
Milling basket stroke:
Tool holder:
Protection class:
Noise emission value:
Noise measurement value determined in accordance
with EN 62841 . The A-rated noise level of the
power tool is typically as follows:
Sound pressure level:
Uncertainty:
Sound power level:
Uncertainty K:
Wear hearing protection!
Vibration emission value:
Total vibration values (vector total of three direc-
tions) determined in accordance with EN 62841:
Hand/arm vibration a
h
Uncertainty K = 1 .5 m/s
NOTE
► The vibration emission values and the noise
emission values given in these instructions
have been measured in accordance with
a standardised test procedure and can be
used for comparison of the power tool with
another tool .
► The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate .
POF 1200 D3
1200 W
230 V∼, 50 Hz
n 11000–30000 rpm
0
n 35000 rpm
max
55 mm
6/8 mm
II / (double insulation)
L = 86 .7 dB (A)
pA
K = 3 dB
pA
L = 97 .7 dB (A)
WA
K = 3 dB
WA
= 4 .3 m/s
2
2
WARNING!
► Depending on the manner in which the power
tool is being used, and in particular the kind of
workpiece that is being worked, the vibration
and noise emission values can deviate from
the values given in these instructions during
actual use of the power tool .
► Try to keep the load as low as possible .
Measures to reduce the vibration load are,
e .g . wearing gloves and limiting the working
time . Wherein all states of operation must be
included (e .g . times when the power tool is
switched off and times where the power tool is
switched on but running without load) .
General power tool
safety warnings
WARNING!
► Read all safety warnings, instructions, illust-
rations and specifications provided with this
power tool. Failure to follow all instructions
listed below may result in electric shock, fire
and/or serious injury .
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool .

1 . Work area safety

a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents .
b) Do not operate power tools in explosive
atmospheres, such as in the presence of flam-
mable liquids, gases or dust. Power tools create
sparks which may ignite the dust or fumes .
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control .
GB │ IE │ NI │ CY │ 3 ■