Inserting A Milling Tool; Connecting The Dust Extraction Adapter; Reducer; Changing The Collet Chuck - Parkside POF 1200 D3 Originalbetriebsanleitung

Inserting a milling tool

♦ Press the spindle locking button
down .
♦ Undo the union nut
se with the open-ended spanner
♦ Release the spindle locking button
♦ Now insert the milling tool .
This must be inserted to a depth of at least
20 mm .
♦ Press the spindle locking button
down .
♦ Tighten the union nut
spanner .
♦ Release the spindle locking button
Connecting the dust extraction adap-
ter
♦ Fit the dust extraction adapter
provided for the dust extraction adapter
♦ Screw the screws
base plate .
♦ Attach an approved dust and sawdust extractor
to the dust extraction adapter

Reducer

Connecting:
♦ Push the reducer
adapter .
♦ Push the hose of a suitable of vacuum cleaning
appliance (e .g . a workshop vacuum) onto the
reducer .
Removal:
♦ Pull the hose of the vacuum cleaner off the
reducer .
♦ Remove the reducer
POF 1200 D3
and hold it
by turning it anticlockwi-
.
.
and hold it
using the open-ended
.
onto the holes
9a
into the underside of the
(see fig . F) .
into the dust extraction
.

Changing the collet chuck

NOTE
► All of the cutters in the supplied cutter set are
equipped with an 8 mm shank .
Use the pre-assembled collet chuck
with them . When using milling cutters with
a 6 mm shank, replace the collet chuck as
described below .
♦ Press the spindle locking button
down .
♦ Undo the union nut anticlockwise with the open-
ended spanner
mm) can be removed .
♦ Fit the collet chuck
ATTENTION! Do not tighten the union nut
with the open-ended spanner
tool is fitted . Otherwise, the collet chuck may be
damaged .
♦ Release the spindle locking button
.

Fitting the rip fence

NOTE
► The oblong holes of the open-ended spanner
can be used to counter tighten the screws .
♦ Unscrew both screws of the sliding rods
a Phillips screwdriver .
♦ Fasten the sliding rods
and tighten the screws .
(8 mm)
and hold it
until the collet chuck
(6 mm) .
unless a milling
.
onto the rip fence
GB │ IE │ NI │ CY │
(8
with
7 ■