Mechanical Installation - Eliwell IWP750 Anleitung

A probe Pb1 (cold room) error causes the following actions:
• Code E1 is shown on the display
• The regulator is activated as indicated by parameters Ont and OFt if set for Duty Cycle.
In order to operate, this controller requires:
• IWK Open horizontal keyboard:
• IWP 750 power module:
Do not install the device in places subject to high humidity and/or dirt; in fact, it is intended for use in sites with ordinary or normal levels of pollution.
Keep the area around the instrument cooling slots adequately ventilated.
A diagram is provided below indicating where to drill the holes required to mount the 2 boards:
IWP750 + IWK HORIZ PLUS DISPLAY
DUTY-CYCLE REGULATOR

MECHANICAL INSTALLATION

open format (116.2x46mm)
on special fixing points (format 160x108mm)
IWK KEYBOARD
IWP750 POWER MODULE
Parameters Ont and OFt
programmed for Duty Cycle
Ont OFt Compressor output
0 0 OFF
0 >0 OFF
>0 0 ON
>0 >0 DUTY CYCLE
6/11