Abnormal Operating Conditions Alarm Signals; Audio System (Optional) - Jacuzzi City Spa Bedienung Und Wartung

CAUTION
Programme the "Silence" function so that it does not interfere
with the filtering cycle (in any case, the total filtering and "si-
lence" time must not exceed 24 hours per day).
NOTES
Do not programme time periods which are too long which could
result in skipping the filtering cycle: the water must always circulate
through the filter.
The "Silence" function disables all functions in progress, with the
exception of the "smart winter" protection.
Abnormal operating conditions
- alarm signals -
A
larms are indicated on the display, with the corresponding error
code. You will continue to see the code if the alarm condition
persists.
Here is a list of the various alarms that may appear. Refer to the
product's installation manual for a detailed description of the vari-
ous messages that may appear on the display.
"LL"
the level sensor detects an inadequate water level. The message "LL"
appears on the display and the spotlight flashes.
It is not possible to activate any function.
- Restore the water level (4-5 centimetres above the highest noz-
zles).
"HI" Excessive water temperature. The term "HI" appears on the
display.
DO NOT ENTER THE WATER
- If present, remove cover from spa.
- If the excessive temperature increase is due to sunlight, add
cold water to the spa.
When the temperature has dropped to below 43 °C (109 °F), the
spa should re-activate automatically. If it does not, disconnect the
power supply and contact an authorized Jacuzzi® service centre.
"Fr" Water temperature is too low.The term "Fr" appears on the
display.
"rPF" Defective temperature probe.
DO NOT ENTER THE WATER
It is not possible to activate any function.
- Contact an authorized Jacuzzi® service centre.

Audio system (optional)

Before you can use the audio system, the MP3 player (not included)
must be able to communicate with the Bluetooth® device. You must
"connect" the devices using a process known as "pairing".
Make sure the spa is powered on (display on).
Follow the instructions in the MP3 player manual on how to
perform "pairing".
NOTE: To use the audio system of the spa, select the Bluetooth® de-
vice called BT Jacuzzi". The access code is 0000.
NOTE: The Bluetooth® device of the spa is found on the side where
the control panel is located, at bottom (see figure). It turns on each
time the spa is turned on.
Once pairing is complete and the connection is established,
you can use the audio system of the spa to listen to your favour-
ite music.
NOTE: Once paired, the MP3 player and the Bluetooth® device of
the spa can connect without the need for pairing to be performed
again. Pairing is necessary if the memory settings are reset, for ex-
ample after a repair or installation (reset).
NOTE: When using the spa, we recommend that you place the MP3
player in a position that is safe from any water splashing from the
spa and to perform selections and adjust settings using the panel
located on the wall of the spa.
USING THE PANEL FOR ADJUSTMENTS
Thanks to the panel located on the wall of the spa, you can easily
control the audio system while you are comfortably in the tub.
Play/pause track
Press the key to pause the track; press it again to resume
playing.
23