Herunterladen Inhalt Inhalt Diese Seite drucken

Hydraulic Connection Water Inlet; Plumbing - Water Drainage - Lotus RDT-105E Bedienungs- Und Wartungsanleitung

Heissluftöfen
Inhaltsverzeichnis

Werbung

2.4 TECNICAL DATA TABLE FOR THE WATER SYSTEM
Water flow rate regulator for
steam generation in combined
cycle.
Water flow rate regulator for
steam generation in steam cycle.
Water flow rate regulator drain
steam condenser.
2.5 HYDRAULIC CONNECTION – WATER INLET
The ovens have a water inlet coupling at the back. Always install an on-off valve between the appliance and the
water mains, making sure it is easy to operate.
We also suggest installing a cartridge filter on the water inlet pipe.
Always use a set of new water joints, eventual old joints must not be used again.
Plumbing connection must be always effected with cold water and rigid pipes.
Never use hoses to connect the oven to the water main.
In the Convection + Humidification models (Fig. 2.5A), the solenoid valve (A) supplies the system, that genera-
tes steam during the combined cycle.
In the Combi Direct models (Fig. 2.5B), the solenoid valve (A) supply the system that generates steam during
the steam cycle; the solenoid valve (A1) supply the system that generates steam during the combined cycle
and the solenoid valve (B) supply the steam condensation system that comes out of the drainpipe.
Note: in the floor models the hydraulic circuit is split as shown in Figures and 2.5C (mod. 20x2/1)
2.6 PLUMBING – WATER DRAINAGE
Drainage for the water is at the back of the oven and
must be connected directly to the end of the stainless
steel drainpipe.
The drain must have no trap and be made in rigid pipes
that can withstand a temperature of 110°C.
Under no circumstances must pipe diameter be redu-
ced. The actual pipe should be at atmospheric pressure
with the appropriate funnel type air intake.
If the drainpipe is clogged for any reason steam can
escape from the door and bad smells can be created
inside in the oven.
7 x 1/1 GN 11 x 1/1 GN 7 x 2/1 GN 11 x 2/1 GN 20 x 1/1 GN 20 x 2/1 GN
Ø 0.4 mm
Ø 0.4 mm
Ø 0.55 mm
Ø 0.6 mm
Ø 0.7 mm
Ø 0.7 mm
Fig. 2.5A
Fig. 2.5B
Ø 0.5 mm
Ø 0.5 mm
Ø 0.6 mm
Ø 0.8 mm
Ø 0.7 mm
Ø 0.7 mm
25
EN
Ø 0.55 mm
Ø 0.5 mm
2 x Ø 0.55
2 x Ø 0.7
mm
mm
Ø 0.7 mm
Ø 0.7 mm
Fig. 2.5C
min. 2°

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis