Dust Extraction; Dust Collection Box; Reducer; Operation - Parkside PMFS 200 A1 Originalbetriebsanleitung

Attaching sanding sheets without using Vel-
cro (see Fig. B on fold page not included in
scope of delivery):
♦ Open the two clamping levers
♦ Push the sanding sheet under the open clamping
rail at one end and clamp it firmly in place
with the clamping lever.
♦ Follow the same procedure at the other end.

Dust extraction

WARNING! RISK OF FIRE!
► When working with power tools that have a
dust collection box or can be connected to
a vacuum cleaner via the vacuum cleaner
adapter, there is a risk of fire! In unfavourable
conditions, e.g. when sparks are flying while
sanding metal or metal residues in wood,
wood dust in the dust bag (or in the bag
of the vacuum cleaner) can spontaneously
ignite. This is a particular risk if the wood
dust is mixed with paint residues or other
chemicals and the workpiece has become hot
after being worked for a long time. Therefore,
do not allow the workpiece to overheat and
always empty the dust box or the dust bag
of the vacuum cleaner before taking a break
from work.
Wear a dust mask.
NOTE
► Perforated sanding sheets are required for
dust extraction.

Dust collection box

Connecting:
♦ Push the dust collection box
multi-sander as far as the stop.
Removal:
♦ Press the release button
box and pull it off backwards.
PMFS 200 A1
.
onto the
of the dust collection
NOTE
► To achieve optimum dust extraction, the dust
collection box should be emptied
regularly.
♦ To do this, remove the dust collection box
from the appliance as described above. Open
the dust box by pulling on the tab
remove the lid. Clean both parts thoroughly by
tapping.

Reducer

Connecting:
♦ Push the reducer
♦ Push the hose of a suitable of vacuum cleaning
appliance (e.g. a workshop vacuum cleaner)
onto the reducer .
Removal:
♦ Pull the hose of the vacuum cleaner off the
reducer .
♦ Remove the reducer

Operation

CAUTION!
► Ensure that the appliance is switched off
before connecting it to the mains.
NOTE
► Always switch the multi-sander on before
making contact with the material, then apply
it to the workpiece.
Switching on and off
Switching the appliance on:
♦ Move the ON/OFF switch
Switching the appliance off:
♦ Move the ON/OFF switch
tion.
and then
into the adapter fitting
.
to the "I" position.
to the "0" posi-
GB
CY
.
7