Before use
GB
CY
Fitting/changing the sanding plate
WARNING!
►
Always remove the plug from the mains
power socket before carrying out any work
on the appliance.
♦
Use the appropriate sanding plate
the corresponding application.
♦
Remove the four screws
♦
Remove the pre-fitted sanding plate.
NOTE
The orbital sander plate
to the appliance in one direction. Please pay
attention to the arrow marks on the orbital
sander plate
point forwards. With the triangular sander plate
the tip points forwards.
♦
Now fit the required sander plate. Ensure that
the mounting plate B is aligned with the sander
plate. The threaded holes of the mounting plate
B must be aligned with the markings on the
appliance (see Fig. A). The rubber pins A
(only on sander plates
in the appliance (see Fig. B).
B
Figure A
6
.
can only be fitted
when doing this. These must
and
) to the holes
A
B
for
Figure B
♦
Replace the four screws
♦
Check that the sander plate is fitted securely.
Select sanding sheet
Removal and surface:
The material removal rate and surface quality are
determined by the grain strength of the sandpaper.
♦
Please note that you need to use sandpapers
with different grains for working the different
materials.
Fitting the sanding sheet
WARNING!
►
Always remove the plug from the mains
power socket before carrying out any work
on the appliance.
NOTE
►
Before fitting a new sanding sheet, remove
any dust and dirt from the sanding plate
.
Attaching sanding sheets using Velcro:
♦
You can attach the sanding sheet to the sander
plate
♦
Ensure that the extraction holes on the sanding
sheet match up with those on the sander plate.
Removing sanding sheets fitted using Velcro:
♦
Simply pull the sanding sheet off the sander
plate
.
using Velcro.
(see Fig. A on fold page).
PMFS 200 A1