Vacuum Dust Extraction; Switching On And Off; Selecting The Correct Rotational Speed And Sanding Belt - Parkside PBS 900 B1 Originalbetriebsanleitung

Preparing for use / Operation
section on "Selecting the correct rotational speed
and sanding belt").
Sanding procedure:
W ith the sander switched on, bring it into con-
tact with the workpiece and move it forward
carefully. Work in parallel and overlapping
widths. Always work in the direction of the grain
to avoid undesirable transverse sanding marks.
After sanding always lift the device from the
workpiece before switching it off.

Vacuum dust extraction

Q
DANGER OF FIRE! There is
the danger of fire when working with electrical de-
vices that have a dustbox or can be connected to
a vacuum cleaner. Under certain conditions the
wood dust in the dust collection box (or in the vacu-
um's dust bag) may self-ignite, e.g. as a result of
flying sparks generated when abrading metals or
metal objects left in wood. This can happen par-
ticularly if the wood dust is mixed with paint residue
or other chemicals and the abraded particles are
hot from prolonged abrasion. Therefore you must
empty the device's dust collection box and the vac-
uum cleaner's dust bag before taking a break or
stopping work and always avoid overheating of
the abraded particles and the device.
Wear a dust mask!
Dust collection with dust collection box
(see Fig. C):
Push the dust collection box
nated fold on the side of the unit with the con-
necting piece .
5
Remove / take out the dust collection box
Pull the dust collection box
10 GB
All manuals and user guides at all-guides.com
Suction adapter (with reducer) (see Fig. C)
Connecting:
Removal:
Q
Q
To switch on intermittent operation mode:
To switch off intermittent operation mode:
To switch on continuous operation mode:
To switch off continuous operation mode:
Q
You can select the belt speed using the belt speed
into the desig- adjuster wheel
10
The optimum belt speed depends on the workpiece
and the workpiece material. Always confirm the best
speed by carrying out a small test. The following
table lists some recommended values to help you
out of the device. determine the optimum speed.
10
Slide the suction adapter
11
piece . If necessary, use the reducer
5
sliding it into the suction adapter
Slide the tube of an approved dust extraction
unit (e.g. a workshop vacuum) onto the suction
adapter , if necessary using the reducer
11
Pull the hose out of the dust extraction unit.
Pull out the suction adapter
the reducer .
13
Operation

Switching on and off

P ress the ON / OFF switch
R elease the ON / OFF switch
P ress the ON / OFF switch
pressed, then press the locking knob
P ress and then release the ON / OFF switch
Selecting the correct rotational
speed and sanding belt
even whilst the sander is running.
1
onto the connecting
by
13
.
11
.
13
, if necessary with
11
.
3
.
3
, and keep it
3
.
2
.
3