Using An Angle Stop; Connecting External Dust Extraction; Operation; Switching On And Off - Parkside PTSG 140 C2 Originalbetriebsanleitung

1. Loosen the screws (7).
2. Set the desired angle via the knurled
nut ( 19) using the angle scale (6).
3. Tighten the screws (7).

Using an angle stop

1. Loosen the angle stop screw (13b).
2. Slide the rail of the angle stop (13a)
into the desired position in the groove
(12) on the sanding table (11).
3. Set the desired angle using the scale
onto the rail marking (13a).
4. Fix the angle stop (13) in place by
tightening the screw (13b).
Connecting external dust
extraction
Please check the operating manual
of your vacuum cleaner to ascertain
whether it is suitable for the suction
of grinding chips.
Connecting external dust
extraction:
1. Place the angle adapter (14) into the
opening on the device.
Ensure that you slide the lug on the
angle adapter (14) into one of the two
slots in the device opening (see de-
tailed illustrations).
2. Rotate the angle adapter (14) into a ver-
tical or horizontal position to secure the
angle adapter (14) against falling out.
Removing external dust
extraction:
3. Gently turn and pull on the angle
adapter (14) to remove it.
It can be removed when the arrow on
the angle adapter (14) and the mark-
ing on the device housing are exactly
aligned.
An additional adapter (15) with a
larger diameter is provided with the
device and this can, if required, be
attached to the angle adapter (14).
If necessary, you can connect the
suction hose of a vacuum cleaner
directly onto the angle adapter.

Operation

Before initial operation, perform a trial run
at top speed without a load for at least 1
minute. Remain outside the hazard area
while doing so.

Switching on and off

Make sure that the power supply
voltage matches the voltage rat-
ing indicated on the device's type
plate.
Connect the machine to the power
supply.
1. Select the desired speed using the
speed regulator (2).
Switching on:
2. Press the power switch "I" (3), the de-
vice starts.
Switching off:
3. Press the off switch „O" (3), the device
turns off.
4. Next, remove the mains cable (5) from
the wall socket.
After switching on the device, wait until the
device has reached its max. speed. Only
then may you commence sanding.
GB MT
37