Hazards Caused By Entanglement; Hazards During Operation; Risks Due To Repetitive Movements; Hazards Caused By Accessories - Parkside PDEXS 150 D3 Originalbetriebsanleitung

Hazards caused by entanglement

■ Suffocation, scalping or and/or cut wounds can
occur if loose clothing, jewellery, necklaces, hair
or gloves are not kept away from the machine
and its accessories .

Hazards during operation

■ When using the machine, the operator's hands
can be subject to hazards such as cuts, grazing
and heat . Wear suitable gloves to protect your
hands .
■ The operator and maintenance personnel must
be physically capable of handling the size,
mass and power of the machine .
■ Hold the machine correctly: be ready to coun-
teract any normal or sudden movements - have
both hands ready .
■ Ensure that your body is balanced and that you
have a secure standing position .
■ Release the start/stop control in case of a dis-
ruption to the electricity supply .
■ Use only lubricants recommended by the manu-
facturer .
■ Avoid direct contact with the movable grinding
disc to avoid squashing or cutting your hands or
other parts of the body . Always wear suitable
gloves to protect your hands .
■ Check the sanding disc before every use . Do
not use if this is cracked, broken or has been
dropped .
■ Avoid direct contact with the movable sanding
disc to avoid squashing or cutting your hands or
other parts of the body . Always wear suitable
gloves to protect your hands .
■ Never use the machine without an abrasive
attachment .
■ There is a risk of electrostatic discharge if the
machine is used on plastic and other non-
conductive materials .
■ Dust and vapours created by the sanding and
sanding can cause a potentially explosive at-
mosphere . Always use a dust extraction or sup-
pression system suitable for the material being
worked .
■ 4 │ GB │ IE │ NI

Risks due to repetitive movements

■ When using a sanding machine for sanding
sheets or a polisher to perform work-related
activities, operators may experience uncomfort-
able sensations in their hands and arms, as well
as in the neck and shoulders or other parts of
the body .
■ When using a sanding machine for sanding
sheets or a polisher, the operator should adopt
a comfortable posture whilst ensuring a secure
hold and avoiding awkward postures or posi-
tions in which it is difficult to maintain balance .
The operator should change positions during
the course of long-lasting tasks . This can be
helpful in the prevention of discomfort and
fatigue .
■ If the operator notices symptoms such as persis-
tent or recurring illness, discomfort, throbbing,
pain, tingling, burning or stiffness, these indica-
tions should not be ignored .
In this case, the operator should consult a suitably
qualified physician .

Hazards caused by accessories

■ Disconnect the sanding machine for sanding
sheets or the polisher from the power supply
before fitting or replacing the machine tools or
accessories .
■ Avoid direct contact with the machine tool during
and after use, since this can have heated up or
have become sharp .
■ Only machine tools which were designed by
the manufacturer for sanding machines with
sanding sheets and polishers may be used
for sanding machines for sanding sheets and
polishers .
■ Cutting discs and machines for cutting may not
be used .
■ Check whether the maximum operational speed
of the machine tool (buffs, sanding sheets, fibre
discs etc .) is higher than the rated speed of the
machine;
■ Self-adhesive sanding discs must be applied
concentrically on the mounting plate .
PDEXS 150 D3