General Safety Instructions For Compressed Air Tools; Hazards Caused By Flying Parts - Parkside PDEXS 150 D3 Originalbetriebsanleitung

Noise emission values:
Noise measurement determined in accordance
with ISO 15744 .
Sound pressure level:
Uncertainty:
Sound power level:
Uncertainty:
Wear ear protection!
Vibration emission value:
Vibration emission value determined in accordance
with ISO 28927-3 and EN 12096:
a = 6 .93 m/s
2
h
Uncertainty K = 1 .22 m/s
WARNING!
► The noise emission levels specified in these
instructions have been measured in ac-
cordance with the standardised measuring
procedure specified in ISO 15744 and can
be used to make equipment comparisons .
The noise emission values vary in accordance
with the use of the compressed air tool and
may be higher than the values specified in
these instructions in some cases . It is easy to
underestimate the noise emission load if the
compressed air tool is used regularly in a
certain manner .
NOTE
► For an accurate estimate of the noise emis-
sion load during a certain working period,
the times during which the appliance is
switched off or is running but not actually
being used must also be taken into considera-
tion . This can significantly reduce the noise
emission load over the total working period .
PDEXS 150 D3
L = 85 .5 dB (A)
pA
K = 3 dB
pA
L = 96 .5 dB (A)
WA
K = 3 dB
WA
2
General safety
WARNING!
instructions for
compressed air tools
WARNING!
► For multiple hazards: Please ensure that you
have read and understood the safety instruc-
tions before adjusting, operating, repairing,
maintaining or replacing accessories on
the sander or working in the vicinity of the
machine . Failure to do this can result in seri-
ous bodily injury .
■ The sanding machine for sanding sheets or the
polisher should only be adjusted, set or used by
adequately qualified and trained operators .
■ This sanding machine for sanding sheets or the
polisher may not be modified . Modifications can
reduce the effectiveness of the safety measures
and increase the risks for the operator .
■ The safety instructions should not be lost – give
them to the operator .
■ Never use damaged sanding machines for
sanding sheets or polishers .
■ The appliance must be inspected regularly to
ensure that it is labelled with the required rated
values and markings given in this manual . The
user must contact the manufacturer to obtain
replacement labels if necessary .

Hazards caused by flying parts

■ If a workpiece or accessory or even part of the
machine tool itself breaks, parts can be flung
out at high speeds .
■ When operating the sanding machine for sand-
ing sheets or the polisher or when exchanging
accessories on the device, always wear eye
protection . The degree of necessary protection
must be evaluated separately for each individual
task .
■ Wear a safety helmet if working above head
height . In this case, the risks for others should
also be assessed .
■ You must ensure that the workpiece has been
securely fixed .
GB │ IE │ NI │ 3 ■