General Safety Instructions For Compressed Air Tools - Parkside PDAP 75 A1 Originalbetriebsanleitung

Noise emission values:
Noise measurement determined in accordance
with ISO 15744:
Sound pressure level:
Uncertainty:
Sound power level:
Uncertainty:
Wear ear protection!
Vibration emission value:
Vibration values determined in accordance with
ISO 28927-3 and EN 12096:
a = 0.25 m/s 2
h
Uncertainty K = 0.52 m/s
WARNING!
► The noise emission levels specified in these
instructions have been measured in ac-
cordance with the standardised measuring
procedure specified in ISO 15744 and can
be used to make equipment comparisons.
The noise emission values vary in accordance
with the use of the compressed air tool and
may be higher than the values specified in
these instructions in some cases. It is easy to
underestimate the noise emission load if the
compressed air tool is used regularly in a
certain manner.
NOTE
► For an accurate estimate of the noise emission
load during a certain working period, the
times during which the appliance is switched
off or is running but not actually being used
must also be taken into consideration. This
can significantly reduce the noise emission
load over the total working period.
PDAP 75 A1
L = 84.1 dB(A)
pA
K = 3 dB
pA
L = 95.1 dB(A)
WA
K = 3 dB
WA
2
WARNING!
General safety instruc-
tions for compressed
air tools
WARNING!
► For multiple hazards: Please ensure that you
have read and understood the safety instruc-
tions before adjusting, operating, repairing,
maintaining or replacement of accessories on
the polisher as well as before working in the
vicinity of the machine. Failure to do this can
result in serious bodily injury.
■ The sander or the polisher should only be ad-
justed, set or used by adequately qualified and
trained operators.
■ This sander or this polisher may not be modi-
fied. Modifications can reduce the effectiveness
of the safety measures and increase the risks for
the operator.
■ The safety instructions should not be lost –
give them to the operator.
■ Never use damaged sanders or polishers.
■ The appliance must be inspected regularly to
ensure that it is labelled with the required rated
values and markings given in this manual. The
user must contact the manufacturer to obtain
replacement labels if necessary.
GB │ IE │ NI │
3 ■