Additional Warnings; Transport And Handling - Stiga ST 1145 E Gebrauchsanweisung

(Translation of the Original Instructions)
causing further damage; in the event of
accidents with injuries to operators or
third parties, take the first aid measures
which are most appropriate to deal with
the situation and contact a health care
facility for the necessary treatment
Carefully remove any debris which
could cause damage or injury to per-
sons or animals if ignored
3 4

ADDITIONAL WARNINGS

Do not use the machine in potentially
explosive environments, in the presen-
ce of flammable liquids, gases or dust.
Electrical power tools generate sparks
which may ignite dust and vapours
Do not overload the machine
Use a machine which is suitable for the
work being performed
A suitable machine will perform the
work better and more safely at the
speed for which it was designed
Keep the extension flex well away from
the auger
The auger may damage the cable and
lead to inadvertent contact with live
parts
Never run the machine over the power
cable
During use, always drag the cable
behind the machine to avoid tripping
over it or it getting hooked onto objects
located in the area in which the snow
thrower is being used
Only plug the snow thrower into so-
ckets with an earth circuit breaker
The earth circuit breaker must trip at
max 30 mA
The machine's power cable, if dama-
ged, must be replaced with a genuine
spare part only This operation must
be performed by your local dealer or a
specialized service centre
The permanent connection of any elec-
trical equipment to the building's elec-
trical network must be carried out by a
certified electrician in compliance with
the relative regulations in force
An incorrect connection may lead to se-
rious injury and even death
ENGLISH
If the electrical cable is damaged du-
ring use, proceed as follows:
• Stop the machine.
• Move away from the machine in the opposite
direction to where the cable is damaged.
• Unplug the cable.
Connect the snow thrower to an appro-
ved cable for outdoor use
Never use the cable improperly
Do not use the cable to transport or pull
the machine Do not pull on the cable to
remove the plug from the socket
Keep the cable away from heat sources,
oil, sharp edges and moving parts
A damaged or tangled cable increases
the risk of electric shock
The machine's plug must be compati-
ble with the socket
Never modify the plug
Do not use adapters with earthed ma-
chines
Unmodified plugs and matching so-
ckets will reduce the risk of electric
shocks
Avoid body contact with earthed or
grounded surfaces such as pipes, ra-
diators, ranges and refrigerators, etc
There is an increased risk of electric
shock if your body contacts earthed or
grounded surfaces
3 5 TRANSPORT AND HANDLING
Whenever it is necessary to move, lift ,
transport or tilt the machine it is neces-
sary to:
• Wear hardwearing work gloves.
• Take hold of the machine in places which offer
a safe grip, taking into account it's weight and
centre of gravity.
• Carry out the operation with as many people as
are needed to handle the weight of the machine
safely and based on the characteristics of the
means or transport or the location where the
machine is to be placed or picked up.
During transport, make sure the machi-
ne is securely fastened with ropes of
chains
EN
7