Trouble Shooting - Parkside PRM 1800 A1 Originalbetriebsanleitung

GB
MT

Trouble Shooting

Problem
Equipment
does not start
Motor stops
Result
unsatisfactory
or motor
labours
Blade ( 19)
I
fails to turn
Strange
noises, rattling
or vibrations
Level indicator
( 17) does
E
not work
34
Possible Cause
Power is off
Defective start lever
( 15)
A
Worn carbon brushes
Defective motor
Grass too long
Blockage by foreign object
Cut height too low
Blade ( 19) blunt
I
Blade ( 19) area blocked
I
Blade ( 19) assembled
I
incorrectly
Blade ( 19) blocked by
I
grass
Blade screw ( 18) loose
I
Blade screw ( 18) loose
I
Blade ( 19) damaged
I
Contamination
Fault Fixing
Check the socket, cable, wire
and plug and have any repairs
carried out by an electrician
Repair by customer services
Set a greater cut height. Lift the
front wheels slightly by pressing
down on the handle bar.
Remove the foreign object
Set a higher cut height
Have the blade (
I
sharpened or replace it
Clean the equipment
Install the blade (
correctly
Remove the grass
Tighten the blade screw (
Tighten the blade screw (
Replace the blade (
Cleaning with a soft brush. The
level indicator must close by
itself, if it was opened.
19)
19)
I
18)
I
18)
I
19)
I